Dentafix Repair Loose Cap

$14.05$17.00

Available: In stock

A ready to use temporary cement that re-fixes dental crowns, inlays, and bridges. It is not glue – it is cement which sets only if...

A ready to use temporary cement that re-fixes dental crowns, inlays, and bridges. It is not glue – it is cement which sets only if it comes into contact with water or saliva and takes approximately 15-20 minutes to set.

This dental cement has been developed to provide an ideal temporary solution. It does not irritate the gums; it is easy to work with and can be easily removed by a dentist without any damage to the bridge or crown.

Please note that this is only a temporary solution and you must consult your dentist as soon as possible. The composition has been tested by clinicians.

Features

Helps with pain relief

Easy to apply

No gum irritation

Sets on contact with oral moisture

Re-fix crowns, inlays, and bridges

Ideal temporary solution

How To Use

• Remove as much as possible of the old, loose cement from inside the bridge or crown. Do not use under force that may damage the crown. Clean the inside of the crown with warm water and soap or detergent and rinse it under running water.

• Remove excess water with a cotton wool bud or tissue.

• Clean the area in the mouth (tooth stump) where the crown is to be replaced. Rinse the mouth with water (do not dry the stump).

• Apply a small amount of the cement around the inner edge of the crown or cap. Do not fill the crown. For bridges, apply a small amount of the cement around the inner edge of each crown of the bridge.

• Press the crown in place for 3 minutes. For bridges fit the bridge back in your mouth and firmly press down with your thumb and fingers. Then carefully bite into place. You will know when the crown or bridge is correctly re-seated as you can close your teeth back together again comfortably. (If you are not satisfied with the fit, you have up to 5 minutes to remove the bridge or crown and repeat the whole process).

• Remove any excess cement from around the base of the crown. The setting of the cement takes approximately 15-20 minutes in contact with oral moisture. Do not chew for the next 3 hours.

Ingredients

DMTG (Glycol) 14%, Ethyl Methacrylate Polymer 4%, Calcium Sulphate 68%, Zinc Oxide 7%, Barium Sulphate 10%, Triacetin 2%.